Filter
Top Products
19
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Switching from stereo to mono
(FM)
If reception is poor, you may get better
sound quality by switching from stereo to
mono in the DSC menu. Each time the ra-
dio is switched on, stereo playback is acti-
vated automatically.
The unit will automatically switch to mono if
the signal received is not strong enough for
stereo playback.
If you would like to switch to mono, refer to
“DSC programming - STEREO/MONO”.
The mode selected is indicated briefly in the
display.
Automatic bandwidth adjust-
ment (SHARX)
In the DSC menu, you can use the SHARX
function to adjust the bandwidth in the FM
frequency range. This can be a great ad-
vantage when there are a large number of
stations within your current reception range.
Interference with strong adjacent stations
can be reduced to an absolute minimum if
you activate SHARX ON (factory setting).
If necessary, refer to the section on “DSC
programming – SHARX”.
To select a scanned station and switch
off Preset Scan:
• Press SCA or the rocker switch briefly.
Scanning stations with Radio
Scan
You can also scan all of the stations within
reception range.
Radio Scan cannot be started unless PTY
is switched off (“PTY” is not highlighted in
the display).
If necessary, switch off PTY on menu level
2. To do so
• press TU and switch off the function by
pressing the corresponding key.
To start the Scan function:
• Press SCA briefly.
All of the stations on the band selected and
within reception range will be scanned one
after the other. “SCAN” and the station name
or frequency will flash alternately in the dis-
play.
To select a scanned station and switch
off the Radio Scan function:
• Press SCA or the rocker switch briefly.
If you do not select a station, the scan func-
tion will automatically switch off after the fre-
quency band has been run through com-
pletely. The unit will tune into the station you
were listening to before you started the scan
function.
Changing the scan time
The scan time can be set from between five
to a maximum of 30 seconds.
Please refer to the section on “DSC pro-
gramming - SCANTIME”.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
If “lo” is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If “lo” does not light up, the radio will also
pick up weaker, more distant stations (high
sensitivity).
If you want to alter the sensitivity level,
please refer to the section on “DSC program-
ming - LO/DX”).
Radio operation with RDS (Radio Data System)