Filter
Top Products
20
19 CAN-Bus Input and Output
CAN-Bus (Controller Area Network) allows several Classé components to
be connected together for simultaneous operation, such as switching from
On to Standby. Using the CAN-Bus Input and Output connectors, the
Classé components can be daisy chained together and controlled via the
CAN-Bus interface.
NOTE: e fi nal component in the daisy chain MUST have a
termination plug inserted into the CAN-Bus output.
For more information, refer to the CAN-Bus section found later in this
manual.
20 10-Channel Analog Outputs
e SSP-800 supports ten analog audio outputs, with both balanced
(XLR) and single-ended (RCA) connections. Connect the appropriate
Front L/R, Sub, Surr L/R, and Rear L/R connectors to the appropriate
power amplifi ers.
NOTE: e Rear L/R connectors are only active when the
SSP-800 output is setup for a 7.1-channel surround system.
e Aux 1 and 2 outputs are programmable and can be used for the
following purposes:
• Assigned as a 2-channel down-mix of the selected multi-channel
signal for either an analog recorder or a separate listening area.
• Assigned to follow the main Front L/R speakers for use in a
biamplifi cation arrangement.
• One or both may be assigned as additional subwoofers with the
ability to select between mono, and stereo modes.
Refer to the Menu System section for more details regarding optional uses
for the auxiliary analog output channels.
NOTE: e Balanced (XLR) Output pin assignments adhere to
the AES (Audio Engineering Society) “Pin 2 = hot” standard. e
XLR male outputs carry the following pin assignments:
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Connector ground lug: chassis ground
Refer to the operating manuals of your balanced-input power
amplifi ers to verify that the pin assignments of their input
connectors adhere to this standard (Classé power amplifi ers are
compliant). If your amplifi ers are not compliant, ask your Classé
dealer for assistance.