Filter
Top Products
26
Connect the Main Analog Audio Outputs, either RCA or XLR, from the
rear panel of the SSP-800 to the corresponding inputs on your amplifi er(s) as
follows:
• Connect the SSP-800 Front Left and Front Right outputs to the
inputs of the amplifi er(s) designated for the Front Left and Front
Right speakers, respectively.
• Connect the SSP-800 centre output to the input of the amplifi er
designated for the centre channel speaker.
• Connect the SSP-800 Left Surround and Right Surround outputs to
the inputs of the amplifi er(s) designated for the Left Surround and
Right Surround speakers, respectively.
• If you are setting up a 7.1-channel system, then also connect the
SSP-800 Left Rear and Right Rear outputs to the inputs of the
amplifi er(s) designated for the Left Rear and Right Rear speakers,
respectively.
• If you are using a subwoofer, connect the SSP-800 subwoofer output
to the input of the designated amplifi er or powered subwoofer.
NOTE: Make sure connections from the subwoofer output go only to an
amplifi er connected to a subwoofer, as low frequency signals can damage a
small full-range speaker not designed for high output bass reproduction.
Verify that each cable is clearly labeled so that you don’t mix them up. When
connecting a cable, make sure the cable has a good connection and is fi rmly
attached to the rear panel connectors on both the amplifi er and the SSP-800.
e SSP-800 also provides two Auxiliary analog audio outputs. See the Rear
Panel section for more details about the Auxiliary outputs.
Step 5 Connect the loudspeakers to the amplifiers.
Important!
Verify that the power amplifier(s) is plugged in but powered
OFF before connecting to the SSP-800!
Connect each loudspeaker to its designated amplifi er(s) channel. Pay close
attention to the phase of the speaker connections – always connect an amplifi er’s
red (+) terminals to the red (+) terminals of the loudspeaker. Likewise, connect black
(–) terminals to black (–) terminals.