Classe Audio SSP-800 Car Speaker User Manual


 
47
Each speaker opens the same menu with two buttons – size and crossover. To
modify the crossover for the selected speaker, touch the Crossover button and
then adjust the setting using the increase and decrease buttons.  e crossover
setting applies a high pass fi lter to the speakers set on crossed over, and a low
pass fi lter to route bass information to the sub (if enabled). When the speaker
is set to large, and e-bass is enabled the crossover determines which low
frequencies will simultaneously get routed to the sub(s).
e Size option allows you to pick either Full Range or Crossed Over for each
speaker.  e None option is available on the surround, center, or rears. Selecting
None disables the channel(s) output. If None is highlighted then that speaker
location is not available for selection in other menus.
NOTE: You cannot disable the Front L/R. If you disable the surround
speakers, then the rear speakers are not available for selection.
e Subwoofer confi guration page, shown above, has two buttons available
Sub Enabled and e-bass. If the Sub Enabled button is highlighted, then the
confi guration includes an active subwoofer and the LFE (Low Frequency Eff ects)
information is routed to it as well as any low pass energy from the crossed
over channels. If you do not enable a subwoofer for the system, then the LFE
information will be routed to any full range speakers in the confi guration. When
a subwoofer is enabled and the e-bass option selected, the low frequency signals
from all speakers (both crossed and full range) are passed to the subwoofer along
with the LFE (if available from a discrete stream).  is eff ectively duplicates the
bass energy present in full range speakers.
NOTE: If the Sub is not enabled e-bass will be grayed out and not selectable
as the LFE is already being distributed to any full range
speakers available.
e Crossover Slope button enables you to select the preferred crossover slope,
either 12dB/octave or a steeper 24dB/octave. Touch the desired value so that it is
highlighted.