Filter
Top Products
46
levels e Levels menu allows you to adjust the output levels of the speakers. An SPL
meter should be used from the primary seating position to ensure that each
speaker delivers the same sound pressure from a given test noise audio signal.
Touch the Noise Seq button to activate the noise generator; the top of the menu
now states “Levels Noise: L” – indicating that the test noise is being generated
on the front left speaker. e test noise automatically moves to each of the
available speakers, as indicated by the menu title, and continues to rotate around
the room until the Noise Seq button is touched again.
NOTE: You may fi nd that some speaker options are not available for
selection. ose speakers do not currently exist in that specifi c confi guration.
e speaker selections for each confi guration are made on the Speakers page,
which hasn’t been discussed yet.
To modify the actual levels, touch the speaker you want to update and then
adjust the level using the increase and decrease buttons. Set the SPL meter to
“C” weighting and Slow response. Each speaker level should be adjusted until
the SPL meter reads 75dB at your main listening position.
in use is button identifi es active confi guration. If the In Use button is highlighted,
then the Confi guration is active. If the In Use button is NOT highlighted, then
the confi guration is considered inactive and is not available for selection in the
Input Setup menu or in the Home page Control section.
speakers e Speakers confi guration page identifi es which speakers are active for each
confi guration, as well as the crossover level for each speaker. e Auxiliary
channels can also be confi gured through this menu.
First, touch the Speaker Confi g button to set up the 7.1-channel speaker
confi gurations. en we will discuss the Auxiliary channel setups.