Filter
Top Products
84
84
Others
About the Steering Wheel Switches
On vehicles equipped with steering wheel switches, these easy-access switches can be used
to perform the main audio and other operations.
● For details of the steering wheel switch, please contact your local dealer.
● This function may not be available depending on the vehicle type.
You can manually assign the desired
functions to every steering wheel switch
buttons.
To do so, turn the power supply off and set it
to the standby state. For details, see “Turning
the POWER ON or OFF” on page 18.
IMPORTANT
● The state of a no signal is read.
● A function is selected in the following
sequence each time you press the button.
TRACK UP Q TRACK DOWN Q VOL UP
Q VOL DOWN Q MODE Q MUTE Q PWR
Q OTHERS ...
● When the function is set correctly, “OK” is
displayed.
ATTENTION
If “NG” is shown on the display, once again
select a desired function to set.
Manual setting of
steering wheel switch
functions
Your manual setting may fail due to the
ambient environments including the outdoor
temperature.
1
When the power switch is off, hold
down both [CTRL] and [TEXT] buttons
for 3 or more seconds.
2
Select “CSTM” using the [SELECT
(Up)] or [SELECT (Down)] button.
3
Press the [BAND] button.
4
Hold down the [CTRL] button.
5
Select a desired function using the
[SELECT (Up)] or [SELECT (Down)]
button.
6
Press the [BAND] button.
7
Hold down the steering wheel switch
button you wish to store in memory,
and simultaneously press the [CTRL]
button more than two seconds.
8
Assign the desired functions to the
steering wheel switch buttons by
repeating Steps 5 through 7.
9
When you have set all functions, hold
down the [BAND] button.