Filter
Top Products
30
Operation
Storing stations into memory
automatically
(The automatic preset mode:
ASM)
The automatic preset mode starts.
[ASM ON] will appear on the display,
and stations are automatically entered
in memory under buttons [1] to [6].
These buttons are called preset
buttons.
ATTENTION
• Pressing the preset buttons ([1] to [6])
allows you to make one-touch station
selections. The frequency of the selected
station is indicated on.
• When a new station is set in memory, the
station previously set in memory will be
deleted.
• If there are fewer than six receivable
stations, the stations set in the remaining
buttons will be retained.
Manually setting stations into
memory
This section covers the setting of stations in
memory under the numbered buttons.
The tuned station is now memorized
and set in the button selected.
Repeat the procedure to set
additional manually tuned stations in
memory, in turn, for buttons [1] to [6].
These buttons are called the preset
buttons.
Preset station scan
This function enables reception of all the stations
in the preset buttons for five seconds each.
[P SCAN] will appear on the display,
and stations stored under preset
buttons [1] through [6] will be played
for five seconds each.
The main unit will stay tuned to the
desired station.
1
Press the [SELECT] (Upper) button
for more than two seconds until a
beep is heard.
CAUTION
If the vehicle’s battery is disconnected (for
repairs to the vehicle or for removing the
main unit), all stations in memory will be
lost. In such a case, set stations in the
memory again.
1
Press the [SELECT] (Left/Right)
button to tune to the station to be
entered in memory.
2
Select any button, from [1] to [6],
and press it for more than two
seconds.
CAUTION
If the vehicle’s battery is disconnected (for
repairs to the vehicle or for removing the
main unit), all stations in memory will be
lost. In such a case, set stations in memory
again.
1
Press the [SELECT] (Lower) button
for more than one second.
2
To stop the preset scan mode at a
desired station, press the
[SELECT] (Lower) button again.