Eclipse - Fujitsu Ten CD3100 Car Stereo System User Manual


 
Names of controls and parts
15
III
Turning the power on and off
When the power is turned on, the state used
when the power was turned off such as CD and
tuner playback is restored.
The power will come ON.
ATTENTION
When the main unit's power is turned on for
the first time or if the battery terminals have
been disconnected because of a reason
such as vehicle maintenance and the power
is then turned back on, the main unit will
start up in FM1 mode. After this, the
broadcast stations will be searched for
automatically and stored in buttons [1] to
[6].
The power will go OFF and the main
unit will be in Standby.
Switching Audio Modes
Press the button to switch mode in the
following sequence:
FM/AM SIRIUS
*1
XM
*1
CD (MP3/WMA)
*2
CDC
*1
AUX
*3
iPod
*1
FM/AM
*1:Cannot be selected if the corresponding
device is not connected to the main unit.
*2:Not displayed if no disc is inserted.
*3:Cannot be selected if the AUX mode is not set
to ON. For details, refer to "Switching the AUX
mode on and off" on page 61.
ATTENTION
The currently selected audio mode is
displayed in the upper right corner of the
screen. (When the switching screen is set to
normal - see page 17).
Adjusting volume
Turn to the right: Increases the volume.
Turn to the left: Decreases the volume.
ATTENTION
Press the [MUTE/Area Shot] button for less
than one second to cut the volume or restore it
instantly.
1
When power is OFF, press the
[SOURCE/PWR] button.
2
When power is ON, press the
[SOURCE/PWR] button until you
hear a beep (for more than one
second).
1
Press the [SOURCE] button for
less than one second.
1
Turn the [VOL] button.
CAUTION
Do not adjust the volume or other controls
while driving the vehicle. Do so only while
parked in a safe location.
Current audio mode