Filter
Top Products
Connection Procedure:
The First step is to purchase or make a straight through cable. We recommend purchasing
one if you have never made a straight through cable. Please remember you can not use a
cross over network cable for this application
Once you have a straight through cable plug one end into the LAN port on the back of the
recorder and the other into the router.
Now Log into the EverFocus DVR menu and using the jog dial from the previous chapter go
to the Network Setting Menu.
If you have a Linksys Router:
Assign an IP address of 192.168.001.050 to the DVR, a Subnet mask of
255.255.255.000, and a default gateway of 192.168.001.001.
If you have a D-Link Router:
Assign an IP address of 192.168.000.050 to the DVR, a Subnet mask of
255.255.255.000, and a default gateway of 192.168.000.001.
If you have a pre-existing LAN:
Go to a Computer on the pre-existing network and do the following:
o Go to Start, then Run and type cmd and click on OK.
Then hit enter, type ipconfig and press enter this will give you the information you will
need.