EverFocus EDR810M Car Stereo System User Manual


 
4. DURATION: The amount of time a motion event will record - from 1 sec to 99 seconds. The
default value is 5 seconds. To change this, simply use the Jog Dial on the DVR.
5. ALARM OUTPUT: This will transmit a signal to another device. The setting of alarms are
NONE = not activated, 1 = output signal 1 transmitted. To change this, simply use the Jog Dial
on the DVR.
6. ALARM EMAIL:
YES: Send an email when motion occurs.
NO: Do not send an email when motion occurs.
The email address and e-mail server can be set in the NETWORK SETUP MENU.
7. ALARM NETWORK:
YES: Enable alarm network when motion occurs.
NO: Disable alarm network when motion occurs.
8. BUZZER: Audible buzzer when motion is detected.
ENABLE: To enable a motion buzzer.
DISABLE: To disable a motion buzzer.
9. MOTION DELAY:
Select motion delay time from 0~7 level.
10. MAIN MON: Display on a main monitor when an alarm occurs.
NO CHANGE: No change on the display in the main monitor when a motion occurs.
FULLSCREEN: A full screen of the active camera will display when motion occurs.
11. CALL MON: Display on a call monitor when motion occurs.
NO CHANGE: No change on the display in the main monitor when motion occurs.
CAMERA 1~8: Display the active camera in full screen mode to the call monitor.
12. SUMMARY: Dial Jog to scroll through options in the SUMMARY table. All alarm’s statuses
are shown in SUMMARY tables. These tables are for checking alarm overall statuses, but not
for changing them.