EverFocus EDR810M Car Stereo System User Manual


 
3. LOG:
ON: Select ON if you wish to record Alarm Events in the Log.
OFF: Select OFF if you do not wish to record Alarm Events in the Log.
4. ACTIVE CAMERA: This field is to activate camera you want to have the alarm enabled too.
For example if you had an external motion detector on camera one you would set this option to
camera one. The Default from the factory is set to on. To change this, simply use the Jog Dial on
the DVR.
Active camera setting, from camera 01~08. You can set the camera which corresponds to
the place where the alarm is located.
Note: The recording camera number in an event depends on the alarm number, and the active
camera images will not be recorded. Example: You assign camera 3 as the active camera to
alarm 1. When the alarm 1 is triggered, camera 3 will be displayed and camera 1 will be
recorded.
5. PTZ PRESET: Select PTZ PRESET from “001” to “255”, so that when Alarm occurs, speed
dome will turn to this preset position for event recording. This function improves surveillance
quality of an alarm event. If you wish to disable this function, please simply select “OFF.
6. DURATION:
1~99 SEC: The amount of time alarm recording, screen change, buzzer and output contact will
last. Adjustable from 1 ~ 99 seconds.
TRANSPARENT: Continuous recording, screen change, buzzer, and output contact for an alarm
event.
7. ALARM OUTPUT: This will transmit a signal to another device. The setting of alarms are
NONE = not activated, 1 = output signal 1 transmitted.
8. ALARM EMAIL:
YES: Send an email when an alarm occurs.
NO: Do not send an email when an alarm occurs.
The email address and e-mail server can be set in the NETWORK SETUP MENU.
9. BUZZER: Audible alarm buzzer.
ENABLE: To enable an alarm buzzer.
DISABLE: To disable an alarm buzzer.