Filter
Top Products
To edit a MOTION AREA, enter a desired channel and press SELECT. Motion must be set to
“Enable” in order to edit the motion detection area.
To quit the motion area edit, press MENU.
To test a motion area: Grids will turn into light red from light green when a motion is
detected.
To clear the motion entire area: Press PLAY to clear the entire motion area.
If you forget the motion grid commands: Press DISPLAY to get a hint window
(shows below) in motion edit mode.
In the motion edit mode:
The default motion area of each camera is entire
screen which displays in light green.
Press COPY to start setting an area.
Use the JOG Dial to move the cursor. Press
ENTER to switch between vertical and
horizontal movement.
Press SEARCH to end and enable the selected
area, or press PAUSE to end and disable the
area.
MENU
COPY
ENTER
SEARCH
PAUSE
- EXIT
- SELECT AREA
- CHANGE DIR
- ON AREA
- OFF AREA