Filter
Top Products
Connecting the antennas
1 Plug the roof antenna cable into the antenna socket »FM ANT
75Ω
« on the hi-fi system.
2 Insert the wires from the loop antenna cable supplied into the
»
AM ANT« terminals on the hi-fi system.
Note:
If no roof antenna is available, use the auxiliary antenna
supplied. When suitably positioned, this antenna provides
reasonably good reception of local FM (VHF) channels. Do not
shorten the auxiliary antenna.
Connecting the loudspeakers
1 Insert the wires of the loudspeaker cable into the terminals for
»
SPEAKERS L+ L– R+ R–«.
– Observe the left and right channels (
L = left channel,
R = right channel).
– Connect the cables marked in red to the red terminals.
Connecting the loudspeaker illumination
You can illuminate the front panel of the loudspeaker similar to the
hi-fi system.
1 Insert the loudspeaker cable plug into the »LIGHT L« and
»
LIGHT R« sockets on the hi-fi system.
Connecting the power cord
Note:
Check that the mains voltage on the type plate (on the back of
the hi-fi system) corresponds to your local mains supply. If this is
not the case, contact your specialist dealer.
1 Insert the supplied mains cable into the »∼AC 230V« socket on
the hi-fi system.
2 Plug the power cord into the wall socket.
Caution:
The hi-fi system is connected to the mains with the power cord. Pull
out the power plug if you want to completely disconnect the hi-fi
system from the mains.
Pull out the mains plug to disconnect the hi-fi system from the
mains. Make sure the power plug is easily accessible during op-
eration and not hindered by other objects.
13
ENGLISH
CONNECTION AND PREPARATION
----
2_UMS_4700_en.qxd 23.10.2007 9:28 Uhr Seite 13