Filter
Top Products
ENGLISH
27
Selecting the tape input source
1 Select the tape input source with »TAPE
≈
« on the hi-fi system or
»
FUNCTION« on the remote control.
– Display: »
TAPE«.
– When a tape is inserted, playback starts automatically
or
select the tape input source with »TAPE
≈
« on the hi-fi system or
»
FUNCTION« on the remote control.
– Display: »
TAPE«.
Open the tape compartment with »
7
/
.
« (under the front flap).
Put a tape in the compartment with the open side facing down-
wards and the full reel on the left side.
Press »
CLOSE« to close the tape compartment.
Tape playback
1 Start playback with »
e
« (under the front flap).
– Playback ends at the end of the side.
2 Pause playback with »II« (under the front flap).
3 Resume playback with »II« (under the front flap).
4 End playback with »
7
/
.
« (under the front flap).
Open the tape compartment by pressing »
7
/
.
« again (under
the front flap).
Fast forward and reverse search
1 In stop mode, press » « or » « (under the front flap).
– » « rewinds to the beginning, » « fast forwards to the
end.
Recording onto tape
Erase protection
Each new recording writes over the previous recording.
You can protect your recordings against inadvertent deletion by
breaking the protection tab in the opening in the spine of the tape.
Purchased recordings on music tapes are already protected against
accidental deletion.
If you wish to record on a protected tape, seal the opening with
adhesive tape.
TAPE MODE
----------------------------------------------------------------------------------
TAPE
2_UMS_4700_en.qxd 23.10.2007 9:28 Uhr Seite 27