Filter
Top Products
ENGLISH
15
Setting the time
The first time you connect the hi-fi system to the mains, it switches to
standby. The time appears in the display. You can only set this in
standby mode.
1 To activate the setting, press and hold down »MEMORY ¥«.
– Display: »
24 H« flashes.
2 Select the hour format (12 or 24 hours) with »–
ß
+
« on the
hi-fi system or »
+« or »–« on the remote control and confirm with
»
MEMORY ¥«.
– Display: the hours flash.
3 Select the time with »–
ß
+
« on the hi-fi system or »+« or »–«
on the remote control and confirm with »
MEMORY ¥«.
– The minutes flash.
4 Set the minutes with »–
ß
+
« on the hi-fi system or »+« or »–«
on the remote control and confirm with »
MEMORY ¥«.
– Display: the current time.
Notes:
The current time is displayed in standby mode.
The time must be reset after a power failure or after disconnecting
from the mains.
Tuning and storing radio stations
You can store up to 15 station in the FM (VHF) frequency range and
up to 15 stations in the MW (medium wave) frequency range on
preset presets.
1 Switch on the hi-fi system by pressing »
8
«.
2 Select the TUNER input source with »TUNER BAND« on the
hi-fi or »
FUNCTION« on the remote control.
3 Press »BAND« to select the frequency band (FM or MW).
4 Set the radio station by briefly pressing »9« or »8«
repeatedly.
– Display: the frequency changes in steps of 50 kHz
or
SETTINGS
----------------------------------------------------------------------------------------------------
1515
FM 93.5
MHz
24 H
00:00
12:00
12:23
2_UMS_4700_en.qxd 23.10.2007 9:28 Uhr Seite 15