Filter
Top Products
3434
Troubleshooting
Not every kind of sound interference is caused by a defect in your hi-fi
system. Cables that have accidentally been disconnected, damaged CDs
and flat batteries for the remote control will impair functioning. If the
following measures do not resolve the problem satisfactorily, please visit
www.grundig.com, product range: hi-fi, micro CD stations or contact your
specialist dealer.
Problem
No sound.
The hi-fi system does not react
when the buttons are pressed.
The remote control does not
work.
Poor radio reception.
Tracks on a CD are skipped.
CD-Rs or CD-RWs are not
played back, or are played
back incorrectly.
Poor sound quality for tape
playback.
No tape recording.
Possible cause/remedy
The volume setting is too low – increase the volume. The head -
phones are plugged in – disconnect the headphones. Power
cable is not properly connected, connect the power cable
properly. Mute is activated, deactivate mute.
Static electrical discharge. Switch off the hi-fi system, disconnect the
power cable and plug it in again after a few seconds.
The batteries are flat. Replace the batteries.
The remote control is out of range of the hi-fi system.
Weak antenna signal, check antenna.
Weak FM stereo signal, switch to mono.
Interference from electrical devices such as televisions, video
recorders, computers, neon lamps, thermostats or motors.
Keep the hi-fi system away from such equipment.
The CD is damaged or dirty – replace the CD or clean it.
The PROGRAM (playlist) or RANDOM functions are active.
Deactivate the functions.
Faulty software or hardware settings during burning or the CD
itself.
Check the components of your CD burner/software or change the
CD being used.
Dust and dirt on magnetic heads, capstan or idler. Clean the
magnetic heads, capstan and idler.
Recording protection tab has been broken off. Cover the opening
with adhesive tape.
INFORMATION
------------------------------------------------------------------------------
2_UMS_4700_en.qxd 23.10.2007 9:28 Uhr Seite 34