Filter
Top Products
10
Driver Installation for Windows XP
This section must be completed
before continuing with the Windows
XP
Auto Setup on page 13
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality.
IBM recommends using
either 1280 x 1024 at a refresh
rate of 60Hz.
To use the Plug and Play feature in Microsoft® Windows® XP files should
be loaded from the IBM Monitor CD.
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to
boot into Windows XP.
4. Open the
DISPLAY PROPERTIES window by clicking START,
SETTINGS, CONTROL PANEL and then double-clicking the DISPLAY
icon.
5. Click the
SETTINGS tab.
6. Click the
ADVANCED button.
7. Click the
MONITOR tab.
8. Click the
PROPERTIES button.
9. Click the
DRIVER tab.
10. Open the Hardware Update Wizard window by clicking on
UPDATE
DRIVER
and then click the NEXT button.
11. Select the “Install from a list or Specific location (Advanced)” and
then click the
NEXT button.
12. Insert the Setup CD into the CD drive and click the
HAVE DISK
button.
13. Click OK.
14. Ensure that the CD drive letter is selected, and then select the
‘Drivers’ folder.
15. Choose
IBM 4943/4944 monitor and click OK. The files will be copied
from the CD to your hard disk drive.
16. Close all open windows and remove the CD.
17. Restart the system.
The system will automatically select the maximum refresh rate and
corresponding Color Matching Profiles.