Filter
Top Products
12
ENGLISH
Auto Setup
Auto Setup
The Setup Utility included on
the installation CD is for
displaying dot patterns.
They do not replace or modify the
display driver.
The Auto Setup instructions require
the monitor to be warmed up for 15
minutes. This is not required for
normal operation.
By pressing the Auto key, you will
have direct access to Auto
Adjustment.
The
AUTO SETUP process
only applies to the current
screen mode. When a new
mode is selected, repeat this section
to reset the monitor.
Auto setup is not required when using digital input.
When you first use your monitor you must perform Auto Setup. This
procedure sets up your monitor to process the video signals from your
computer without image discoloration or smearing. After you perform Auto
Setup, the settings are stored and used each time you turn on the
monitor.
To optimize the displayed image a set-up utility is provided on the CD.
Operation of the utility is dependent on the operating system on your
computer. For correct operation locate the operating system on your
computer from the table below and follow the appropriate instructions.
You can choose to run
AUTO SETUP for each operating system that you use.
This means that if you sometimes use your monitor while running a
version of Windows and sometimes also use it from within DOS (not a
DOS window), you must run
AUTO SETUP for both Windows and DOS. You
can run versions of
AUTO SETUP in any order.
Operating System Corresponding Auto Setup procedure
DOS
Auto Setup for DOS on page 12
Windows 2003, Windows Me,
Windows XP or Windows Vista
Auto Setup for Windows 2003, Windows Me,Windows XP or
Windows Vista on page 13
Before you begin AUTO SETUP for your computer:
Make sure the computer’s video mode is set in the range of the supported
screen resolution shown in the Table on page 20.
You should perform
AUTO SETUP for each screen mode you use.