Filter
Top Products
6
Connecting your Monitor for Analog
Be sure to read the 'Safety'
Information located in the Monitor
Safety and Warranty Guide before
carrying out this procedure.
1. Turn off your computer and all attached devices.
2. Tilt the monitor all the way forward.
3. Connect the analog signal cable to the VGA video port on the back of
your computer.
This port might be directly attached to your computer (figure A), or it might
be part of a video adapter card (figure B). The analog video port on your
computer or video adapter card is normally blue to match the blue
connector on your monitor’s analog video cable.
4. Attach the power cord at the back of the monitor where it says “AC
IN”. The arrow in the drawing below indicates the approximate area:
5. Insert the power plug into a properly grounded electrical outlet.