Filter
Top Products
1-16 (No.MA165)
3.1.14 Removing the panel board
(See Figs.20 and 21)
• Remove the panel assembly.
(1) From the back side of the panel assembly, remove the sev-
en screws U attaching the rear cover to the panel assem-
bly. (See Fig.20.)
(2) From the inside of the rear cover, release the lock of the
connector CN582
on the panel board and disconnect the
card wire. (See Fig.21.)
(3) Remove the five screws V attaching the panel board and
take out the panel board from the rear cover. (See Fig.21.)
3.1.15 Removing the switch board
(See Figs.20 and 22)
• Remove the panel assembly.
(1) From the back side of the panel assembly, remove the sev-
en screws U attaching the rear cover to the panel assem-
bly. (See Fig.20.)
(2) From the inside of the panel assembly, release the lock of
the connector CN583
on the switch board and disconnect
the card wire. (See Fig.22.)
(3) Take out the switch board from the panel assembly.Take
out the switch board from the panel assembly.
Note:
Do not lose the compression spring when taking out the switch
board. (See Fig.22.)
Fig.20
Fig.21
Fig.22
U
Rear cover
Front panel assembly
U
U
Panel board
V
V
V
Rear cover
CN582
Lock
Panel assembly
CN583
Lock
Switch board
Compression spring