Filter
Top Products
70
CONNECTION/INSTALLATIONCONNECTION/INSTALLATION
R Connecting the GPS antenna
Connect the GPS antenna (0) to the GPS terminal.
• To install the GPS antenna, fix the metal plate
(-) firmly on the dashboard, then place the GPS
antenna (0) on the metal plate (-).
– Clean the dashboard or other surface
beforehand.
– Install the GPS antenna (0) inside of the car, as
horizontally as possible to allow easy reception
of the GPS satellite signals.
– You can bend the metal plate (-) to conform to
a curved surface, if necessary.
0
-
0
• Depending on the type of car, reception of the
GPS satellite signals might not be possible with an
internal installation.
• Install this GPS antenna in an area away from any
antennas that are used with CB radios or satellite
televisions.
• The GPS antenna should be installed at a position
that at least 30 cm (12 inches) from mobile phone
or other transmitting antennas.
• The above types of communication may interfere
with signals from the GPS satellite.
• Painting the GPS antenna with (metallic) paint
may cause reduced performance.
Removing the unit
RRemoving the trim plate
1 Engage the catch pins on the extraction
key (4) and remove the two locks on the
lower part. Lower the frame and pull it
forward.
4
2 Remove from the upper two catches.
• The frame can be removed from the top side in
the same manner.
RRemoving the unit
1 Remove the trim plate. (See the left
column.)
2 Insert the two extraction keys (4), then
pull them as illustrated so that the unit can
be removed.
4
• Be careful to avoid injury from the catch pins on
the extraction key.