Filter
Top Products
38
|
English
Removing the Unit
Removing the hard rubber frame
1 Upper the frame and pull it forward as shown in
the figure.
2 When the upper level is removed, remove the
lower two locations.
• The frame can be removed from the bottom side in the
same manner.
• When you mount the "hard rubber frame," take care to
face its upward and downward sides correctly. The side
having closer claws must face upward, and the one
having wider claws must face downward.
Removing the Unit
1 Refer to the section 'Removing the hard rubber
frame' (page 38) and then remove the hard
rubber frame.
2 Remove the screw (M4 × 8) on the back panel.
3 Insert the two removal tools deeply into the slots
on each side, as shown.
• Be careful to avoid injury from the catch pins on the
removal tool.
4 Pull the unit all the way out with your hands,
being careful not to drop it.
Lock
Accessory2
Removal tool
Screw (M4X8)
(commercially available)
Face the side having
a projection inward.