Filter
Top Products
1. SAFETY
Before applying power
IMPORTANT!
U.S.A. and Canada
Units shipped to the U.S.A. and Canada are designed
for operation on 120 volts AC only. These units are not
equipped with an AC voltage selector switch and the
discussion of such a switch that follows should be
disregarded.
All other countries
Units shipped to countries other than the U.S.A., Cana-
da are equipped with an AC voltage selector switch on
the rear panel. Refer to the following paragraph for the
proper setting of this switch.
AC voltage selection
This unit operates on 120 volts, 220 volts or 240 volts
AC. The AC voltage selector switch on the rear panel is
set to the voltage that prevails in the area to which the unit
is shipped. Before connecting the power cord to your AC
outlet, make sure that the setting position of this switch
matches your line voltage. If not, it must be set to your
voltage in accordance with the following direction.
Note:
Our warranty does not cover damage caused by excessive
line voltage due to improper setting of the AC voltage se-
lector switch.
WARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
Safety precautions
Before plugging in this unit, make sure that the position
of the AC voltage selector conforms to your line (mains)
voltage. If not, it must be reset.
AC voltage selector switch
For United Kingdom
The mains plug
must
be removed from the wall
socket
prior to any internal examination.
Warning:
This apparatus must be earthed.
Important
The wires in this mains lead are coloured in accordance
with the following code:
Blue
Neutral
Brown
Live
Green-and-yellow
Earth
The wires in this mains lead must be connected to the
terminals in the plug as follows:
Notes:
1)
If a 13-amp plug is used, this must be fitted with a
3-amp fuse.
2)
If a 3-pin plug with earthing contact is used, no wire
must be connected to the E terminal.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALI-
FIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended
to alert the user of the presence of uninsulated "dangerous voltage" within the pro-
duct's enclosure; that may be of sufficient magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user of
the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
2