Filter
Top Products
B. Time set
1. Select the CLOCK for which the time is to be set.
2.
Press the TIME SET switch.
3.
Simultaneously press the HOUR and MINUTE keys to
stop the clock.
The colon on the clock display lights continuously, indi-
cating that the clock has stopped and that you can now
begin programming.
(Example)
4.
Set the desired time using the HOUR and MINUTE keys.
(Example)
5.
Turn the TIME SET switch to OFF; the colon on the
clock display starts blinking, indicating the new time.
Synchronizing your clocks to a known time standard such
as WWV
or
JJY.
1.
Set CLOCK 1 according to the instructions above.
2.
Set the time of CLOCK 2 so that it is one minute ahead
of the time you wish to begin.
For example, the present time is 5:59 UTC and you
want the synchronization to begin at 6:00 UTC, so you
would set CLOCK 2 to read 6:00.
3.
To start the clock you would turn the TIME SET switch
OFF in synchronization with the tone signal generated
by the appropriate time standard. This will automatical-
ly synchronize both CLOCK 1 and CLOCK 2 to the time
standard.
Note:
An error of 1 minute between the minutes displayed on
CLOCK 1 and CLOCK 2 may occur if both clocks are not
displaying the same number of minutes, i.e. CLOCK 1
:59:00 and CLOCK 2:00:00 when you set
_ _
CLOCK 2.
4-5-3. Timer
A. ON TIME set
You can program the R-5000 to turn ON or OFF in synch-
ronization with CLOCK 1. (The timer will not be controlled
by the time set in CLOCK 2.)
The time programmed with the ON TIME switch is used to
turn the R-5000 ON at the selected time. To set the turn
on time:
1. Press the TIME SET switch.
2.
Press and hold the ON TIME switch. The display will in-
dicate:
(Example)
3.
Set the desired time using the HOUR and MITUTE keys.
(Example)
4.
Release the ON TIME switch and the TIME SET switch.
5.
Timer operation begins when the TIMER switch is
turned ON.
Notes:
1.
The timer will not function if the TIMER SET switch is
left ON; be sure to turn the switch OFF after setting the
timer.
2.
If you simultaneously press the HOUR and MINUTE
keys, the associated timer will be reset. (TIME ON or
TIME OFF).
3.
If you have not set either an ON time or an OFF time,
nothing will happen when you press the TIMER switch.
4.
When the TIMER is operating, a red asterisk (*) appears
in the display.
5.
When the TIMER is operating, the POWER switch does
not function.
B. OFF TIME set
The OFF TIME turns the R-5000 OFF at the desired time.
1.
Press the TIME SET switch.
2.
Press and hold the OFF TIME switch; the display will
indicate:
(Example)
3.
Set the desired time using the HOUR and MINUTE keys.
4.
Release the OFF TIME switch and the TIME SET switch.
5.
Timer operation begins when the TIMER switch is
turned ON.
C.
ON/OFF operation
If both the ON time and the OFF time are set, the ON and
OFF times are synchronized with CLOCK 1. The ON/OFF
cycle is then repeated daily, as long as the TIMER switch
in ON.
D.
Checking the programmed times
To check the programmed times, press the ON TIME or
OFF TIME switch.
Note:
You may check the times with the POWER swiltch ON or
OFF, but you must program the TIMER with the POWER
switch ON.
26