Filter
Top Products
OPERATING FEATURES
C
4.
Transceiver Programming
Ir
4-1.lntroduction
The TK-9401941
transceiver
IS
programmed uslng an
IBM PC or compatlbe machlne, a programming Inter-
face
(KPG4), and a programmlng dlsk (KPG-25D)
Fig-
ure 4 shows the setup for an IBM PC
..
Programming
disk
(KPG-25D)
Fig. 4
4-2.
KPG-4 Description
(Optional PC programming interface cable)
The KPG-4 is reeded to connect the TK-9401941 to
the computer. It has a circuit in the D-subconnector
(25-pin) case that converts the RS-232C logic level to
TTL
level. The KPG-4 plug is connected to external
socket of the TK-9401941 and to the computer by a
conversion cable (option) with a 9-pin female
connector and a 25-pin male connector.
4-3.
Programming Software Description
KPG-25D is the programmlng software for the TK-
9401941, supplled on a 3 5" or 5.25" floppy disk Thls
software runs under MS-DOS (vers~on 3.3 or later) on
an
IBM /XT, AT, or PS2, or on a compatible mach~ne
'
Data car, de Input to or read from the TK-9401941, and
ed~ted on the screen Programmed data can be
4-4. Data Program Mode
In thts mode, data
IS
wr~tten Into the flash memory
In the transceiver, When the power
IS
turned on, data
program mode can be entered
~mmedlately. When the
KPG-4
IS
connected and commands can be received,
"PROGRAM"
IS
displayed
to ~nd~cate that data program
mode has been entered
Tunlng can be done uslng an IBM PC and KPG-25D,
In the same way as In panel tun~ng mode You can
carry out panel
tunlng by select~ng test mode on the
KPG-25D menu screen and
follow~ng the ~nstructions
on the screen See the KPG-25D Instruction manual
for
detalls