Filter
Top Products
1
OPERATING FEATURES
3-13. Free System Ringback
>
)
Thls feature is avalabe only when a telephone inter-
connect ID code
IS
selected. If a busy tone sounds
when the
PTT button
IS
pressed, the transceiver enters
this mode
automat~cally.
When the PTT button is released, a beep sounds for
400ms to indicate that the mode has been entered. If
the scan
IS
on, it is resumed (the
a
mark goes on.)
When any repeater becomes available, a ringing tone
so~~nds and this mode ends.
The mode is terminated when the system, group,
scan,
Pn,
or AUX key is changed.
3-14. System Search
Th~s feature can be programmed to automat~cally
access other programmed systems when the selected
system cannot be accessed If an Intercept tone
1
sounds when the PTT button
IS
pressed after setting
the moae, the transcelver has entered the mode
c
If the group ID
IS
a telephone Interconnect ID, the
transcelver then attempts to access,
In
succession,
[
other systems that have a telephone tnterconnect ID in
g
the revert group locatlon
If the group ID
IS
a dlspatch
ID, the transcelver attempts to access other systems
that have a
dlspatch
ID
programmed In the revert
group
locatlon
If there
IS
no system to be accessed, an Intercept
tone
sbunds, the mode
IS
termlnated, and the trans-
celver returns to the flrst system If the access
IS
suc-
cessful, the mode
IS
termlnated, and the searched sys-
tem becomes the new selected system
(If durrng
scannlng, the scan stops
)
3-15. Transpond
Thts feature can be programmed to turn on and off
each group. If the
ID
of the group for which trans-
d
IS
enabled is received, two data messages (trans-
ID
and turn-off code) are automatically transmitted
mmed to turn on or off for
button is pressed for the
nd feature is set, the home
r transmission, and the re-
rformed. Signaling must
3-17. Preferred System Revert
This feature is available by assigning this feature to
the AUX
(Aux~liary) key The feature is used to move
the revert
system/group to the fixed programmed sys-
temlgroup qu~ckly. When the AUX key
IS
pressed
during scanning, the scan stops temporarily, and the
revert
systemlgroup is displayed. The scan resumes
about one second after the AUX key is released.
3-18. Alphanumeric Display Select
The systemlgroup number display and the alphanu-
meric display can be switched with the AUX key by
assigning this feature to the key. Figure
2
shows the
characters that can be displayed. These are basic char-
acters, and can be displayed in each segment.
Four
digits can be displayed at the same time.
----
I7
71-
Ill I I I I,
1-1
h
I I I I--
1-
!--I
1-1
ABCDEFGHI
JKLMNOPQR
STUVWXYZ
-
;
Fig.
2