Filter
Top Products
2-9
SECTION 2
INSTALLATION
D. INSTALLING THE CONVEYOR FRAME AND BELT
FOR ALL TYPES OF OVENS, ENSURE THAT THE
DRIVE SECTION/END OF THE CONVEYOR FRAME IS
PLACED ON THE SAME END OF THE OVEN AS THE
CONVEYOR DRIVE MOTOR.
1. Insert the conveyor frame into the oven as follows:
For a TANDEM or DOUBLE TANDEM oven,
slide one hinged conveyor frame section
into each end of the oven. The two
sections butt against each other at the
gap between the two oven sections. See
Figure 2-18.
For TRI TANDEM ovens, slide one intermediate
frame section into the oven (from either end).
Center this section inside the oven.
Then, slide one intermediate
section and one end section of
the frame into EACH END of the
oven. All five sections should
butt against each other. See
Figure 2-19.
For QUAD TANDEM ovens, slide two intermediate
sections and one end section of the frame into EACH
END of the oven. Butt the two inner intermediate
sections against the transition (center) frame
section. The other frame sections
should butt against each other.
See Figure 2-20.
Figure 2-18
Tandem and Double Tandem
Conveyor Installation
Figure 2-19
Tri Tandem Conveyor
Installation
Figure 2-20
Quad Tandem Conveyor Installation
Intermediate
sections
Center section
(transition)
Intermediate
sections
End
section
End
section
End
section
End
section
Hinged
end section
Hinged
end section
Intermediate
sections