Filter
Top Products
2-14
SECTION 2
INSTALLATION
Certain safety code requirements exist for the installation
of gas ovens; refer to the beginning of Section 2 for a list of
the installation standards. In addition, because the oven is
equipped with casters, the gas line connection shall be
made with a connector that complies with the Standard for
Connectors for Movable Gas Appliances, ANSI Z21.69 (in
U.S.A.), or, if applicable, Connectors for Movable Gas
Appliances, CAN/CGA-6.16 (in Canada), as well as a
quick-disconnect device that complies with the Standard
for Quick-Disconnect Devices for Use With Gas Fuel,
ANSI Z21.41 (in U.S.A.), or, if applicable, Quick-Discon-
nect Devices for Use With Gas Fuel, CAN1-6.9 (in Canada).
B. GAS CONVERSION
It is possible to convert ovens from natural to propane gas,
or from propane to natural gas, by changing the main and
pilot orifices.
WARNING: All installations, conversions and service work
must be performed by an authorized service agent.
NOTE: In Canada, to conform with the CAN/CGA-B149.2
propane installation code, the oven must be ordered
propane. It may not be converted in the field.
Figure 2-28
Flexible Gas Hose Installation
Appliance
Connection/Male
Nipple
Flexible
Gas Hose
Full-Flow Gas
Shutoff Valve
To Gas
Supply Pipe
90°
Elbow
Manual
shutoff valve
Pilot pressure tap
(where pilot gas
pressure is measured)
Combination Gas
Control Valve (Safety
Regulator)
Inlet pressure
tap (where
incoming gas
pressure is
measured)
Manifold
pressure
tap (where
manifold gas
pressure is
measured)
On/Off Knob - Always
leave in ON position
Low Flame
Bypass Line
High Flame
Solenoid Valve
Burner Blower
Gas Burner
Figure 2-29
Gas Burner and Piping Assembly