Filter
Top Products
2-11
SECTION 2
INSTALLATION
Latches
Latches
Figure 2-24 - Transition Section Final Assembly
Figure 2-25
Conveyor Motor and Drive Chain Assembly
5. For a TANDEM, DOUBLE TANDEM, or TRI TANDEM
oven installation, skip ahead to Step 9. For a QUAD
TANDEM oven installation, continue on to Step 6.
6. Slide the top transition panel into place. Then, slide
the two transition side panels into place. See Figure
2-24.
7. If the four latches are not already attached to the side
and top transition panels, attach them in place as
shown in Figure 2-24.
8. Fasten the latches on the side and top panels to hold
the panels in place.
9. LOOSELY attach the conveyor drive motor to the end
wall of the oven, as shown in Figure 2-25.
10. Assemble the conveyor drive chain in place on the
motor and conveyor drive sprockets.
11. Position the motor to adjust the tension of the drive
chain. The deflection of the chain should be 3/4
(19mm). DO NOT OVERTIGHTEN THE DRIVE CHAIN.
Then, tighten the motor in place.
12. Assemble the end plugs and motor housing onto the
oven.
13. TANDEM AND DOUBLE TANDEM OVENS ONLY:
Assemble the end stops, conveyor crumb trays, and
conveyor extension covers onto the oven. These
components are illustrated in Figure 1-1 (Page 1-2).