Filter
Top Products
English-14
3. Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram below.
4. To avoid monitor from falling
When installing the monitor using the tabletop stands (op-
tional), take measures to prevent the monitor from falling over
in case of an earthquake or other disaster to lessen the prob-
ability of injury and damage resulting from fall.
As shown in the fi gure, secure the monitor to a solid wall or
pillar using rope (commercially available) strong enough to
bear the weight of the monitor. (MDT421S: approx. 27 kg (with
the optional stands))
When you use screw hooks (commercially available), ring
screw hooks, not C-shaped screw hooks (with opening), are
recommended.
Caution:
• The effectiveness of preventing from falling substantially
depends on the strength of brackets and base to which
prevention device from falling is attached. When you
cannot ensure suffi cient strength, provide adequate
reinforcement.
• Though the recommended prevention from falling is
intended to lessen the probability of injury and damage, it
doesn’t assure its effectiveness against any kind of
earthquake or disaster.
• Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
• Before moving the monitor, remove the rope that is
securing the monitor. Failure to do so may result in injury
or breakdown of the monitor.
You can attach mounting accessories to the LCD monitor in
one of the following two ways:
1. In the upright position
2. Lay the screen face down
Lay the protective sheet on a table, which was wrapped
around the monitor when it was packaged, beneath the
screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow correct
mounting procedures could result in damage to the equip-
ment or injury to the user or installer. Product warranty does
not cover damage caused by improper installation.
Failure to follow these recommendations could result in void-
ing your warranty.
Use M6 screws (having a length 10 mm longer than the thick-
ness of the mounting bracket) and tighten them securely.
Prevent the screws from loosening using spring washers,
etc. MITSUBISHI ELECTRIC recommends using mounting
interface that comply with TÜV-GS and/or UL1678 standard
in North America.
Caution:
For preventing the monitor from falling.
• Install the monitor with metal brackets for wall or ceiling
installation (commercially available) on your own respon-
sibility. For detailed procedures of installation, refer to the
instructions of the metal brackets.
• To lessen the probability of injury and damage resulting
from fall of the monitor in case of earthquake or other
disaster, be sure to consult the bracket manufacturer for
installation location.
• To lessen the risk of falling of the monitor, thread commer-
cially available rope through the handles at the right and
left of the monitor and secure the rope to the wall mount
brackets or ceiling mount brackets.
• Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
How to Mount and Attach Options to the LCD Monitor
Screw Holes
400 mm
Screw hook, etc.
commercially available
Clamper
Screw
Rope, etc.
commercially available
482.8 482.8
100 100 100100
100100
279.3279.3
Table Handles Protective sheet
(mm)
Downloaded From TV-Manual.com Manuals