Filter
Top Products
28
Chapter6Reference
Chapter 6 Reference
6-1. How to Attach the Optional Arm
An optional arm (or an optional stand) can be attached by removing the stand section.
Attention
• When attaching an arm or stand, follow the instructions of their user’s manual.
• When using another manufacturer’s arm or stand, conrm the following in advance and select one conforming to the VESA
standard. Use the screws securing the unit and the stand.
-
Clearance between the screw holes: 100 mm × 100 mm
-
Thickness of plate: 2.6 mm
-
Strong enough to support weight of the monitor unit (except the stand) and attachments such as cables.
• When using another manufacturer’s arm or stand, use the screws as described below.
-
Screws supplied with this product (M4 × 12 mm)
• When using an arm or stand, attach it to meet the following tilt angles of the monitor.
-
Up 60˚, down 45˚
• Do not turn the monitor in the vertical direction.
• Connect the cables after attaching an arm or stand.
• The monitor and arm or stand are heavy. Dropping them may result in injury or equipment damage.
Procedure
1.
Lay the LCD monitor on a soft cloth spread over on a stable surface with the
panel surface facing down.
2.
Remove the stand.
Prepare a screwdriver. Loosen the screws (four) securing the unit and the stand with the screwdriver.
3.
Remove the adapter.
Loosen the screws (four) securing the adapter to the unit using the screwdriver.
4.
Attach the arm or stand to the monitor.
Secure the monitor to the arm or stand using the screws specied in the user’s manual of the arm or stand.
Adapter