Filter
Top Products
13
Wireless LAN setup: Before configuring the WLAN network, insert the USB 802.11n Wi-Fi Dongle.
To setup the WLAN connection, you will go through the steps below. In each step, setup and press
“ENTER” to continue or press “RETURN” to previous step.
Profile: Choose one profile to edit or apply. The saved profile can be applied later. To apply the
profile, choose it and press blue key to apply. In the first setting, choose “Connection 1” and
press “ENTER” key to continue.
Connection: Select either to use “Infrastructure (AP)” or “Peer to Peer (Ad Hoc)”. The Infrastructure
mode requires an Access Point to access and the Ad Hoc mode is for the dongle to
dongle network.
The procedure divides into two ways here.
Infrastructure AP Mode:
Get SSID: select one SSID which is the network name for AP and then press “Enter” to continue.
Signal Strength: in this page, you can find the signal strength for every SSID. Adjust the position,
angle of the dongle or AP to get the high signal strength.
Connection
Profile
Peer to Peer
Ad Hoc
Infra AP
Get SSID
(Scan WLAN)
1. Setup SSID
2. Security
Enter the key
Enter the key
DHCP
FIX IP
FIX IP
WLAN mode WLAN Setup
Security Setup
IP Setup Profile
OK
OK