Filter
Top Products
Troubleshooting—Continued
48
CD Playback
Playback jumps.
• The CD receiver is being subjected to vibration or the disc is scratched or dirty (see page 11 to 12).
Can’t add tracks to the playlist for memory playback.
• Make sure there’s a disc in the CD receiver. Also, you can only add valid track numbers. For example, if the
CD contains 11 tracks, you cannot add track #12.
The disc will not play.
• Make sure the disc has been loaded correctly, with the label-side facing up.
• Check to see if the surface of the disc is dirty (see page 11 to 12).
• If condensation is suspected, unplug the power cord and leave CD receiver for two to three hours in the room
temperature before playing any discs.
• Some CD-R / RW discs may not be playable (see page 11).
It takes a long time for playback to start.
• It may take the CD receiver a while to read CDs that contain many tracks or files.
Can’t play MP3 / WMA DISCs.
• Use only ISO 9660 Level 1 or Level 2 format discs (see page 11).
• The disc has not been finalized. Finalize the disc.
• Check whether the file format is supported (see page 11).
• MP3 / WMA files without a “.MP3 / .WMA” or “.mp3 / .wma” filename extension are not recognized.
USB Flash Drive Playback
Can’t access the music files on a USB Flash Drive.
• The CD receiver's USB port supports only USB Flash Drives. Do not connect a USB-connection MP3 player
or HDD, etc. Personal computers and iPod models, etc., cannot be connected.
• If “No Media” or “Reading” remains displayed on the CD receiver, eject the USB Flash Drive once, wait a
few seconds and then insert it again.
• Check that the format is FAT16 or FAT32, and the cluster size is 32K bytes or less.
• USB Flash Drives with an internal USB hub are not supported.
Can’t play MP3 / WMA files.
• Check whether the file format is supported (see page 30).
• MP3 / WMA files without a “.MP3 / .WMA” or “.mp3 / .wma” filename extension are not recognized.
• The MP3 / WMA file’s copyright option is on. Don’t use the copyright option.
Tuner
Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn’t
preset all stations, or the ST indicator doesn’t light up when tuned to a stereo FM station.
• Check the antenna connections (see page 13 to 14).
• Change the position of the antenna (see page 34).
• Move the CD receiver away from a nearby TV or computer.
• Cars or airplanes can cause noisy interference.
• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
• Try setting FM mode to mono (see page 34).
• Move power cords and speaker cables as far away as possible from the tuner’s antenna.
• When listening to an AM station, noise may be heard when you operate the remote controller.
• If none of the above improves the reception, install an outdoor antenna (see page 14).
If a power outage occurs or the power cable is disconnected:
• If the preset stations are lost, preset them again (see pages 37 to 38).
• The clock and timer settings will be lost. Set the clock and timers again (see pages 42 to 46).
DAB reception is poor:
• Check the connections, and adjust the location and position of antenna. After that, execute Auto Scan
function manually (see page 35).
• Adjust the location and position of antenna with Tuning Aid function (see page 37).
• If the reception environment changed by removal, etc., execute Auto Scan function manually (see page 35).