Onkyo CR-545 CR-545UKD Car Stereo System User Manual


 
Troubleshooting—Continued
49
Can’t adjust the frequency of the radio.
Use the remote controller’s [ ] / [ ] buttons to change the frequency of the radio.
RDS doesn’t work.
The FM station you are tuned to doesn’t support RDS.
Install an outdoor FM antenna (see page 14).
Change the location and position of your outdoor FM antenna.
Move the FM antenna as far away as possible from fluorescent lights.
iPod / iPhone
“Cannot Use HP” appears on the display
When you select iPod as the input source, the headphones output no sound. Remove the headphones and use
the speaker. If use headphones, connect it directly to iPod.
No sound
Make sure that your iPod is compatible with the system (see page 5).
Make sure that the iPod is securely inserted in the dock. Remove your iPod from its case before inserting it.
Confirm that the CD receiver’s INPUT is set to iPod, and that the iPod is set to PLAY.
iPod does not respond to the CD receiver buttons or enclosed remote control
Confirm that the CD receiver’s INPUT is set to iPod.
Make sure that the iPod is securely inserted in the dock. Remove your iPod from its case before inserting it.
If the iPod is sleeping, wait for the iPod to wake up and start.
If “iPod No Device” is displayed, remove your iPod once, wait a few moments and then connect it again.
Some functions may not be available depending on the iPod model, software version or contents being
played. Update the iPod software to the latest version.
The iPod item (highlighted) can be moved by [ ] / [ ] buttons during the (iPod menu mode
indicator) is lit. If the tracks are skipped by pressing [ ] / [ ] buttons, press the remote controller’s
[MENU / CLEAR] button and confirm the indicator on the display. Then press [ ] / [ ] buttons.
External Components
No sound is heard from a connected component.
Make sure the correct input source is selected (see page 18).
Make sure the analog audio cable is connected correctly (see pages 16).
Make sure that all audio connecting plugs are pushed in all the way (see page 16).
No sound is heard from your turntable.
Make sure the turntable has a built-in phono equalizer.
If the turntable doesn’t have a phono equalizer built-in, you must provide one.
Remote Controller
The remote controller doesn’t work properly.
Make sure the batteries have been installed with the correct polarity (+ / –) (see page 6).
Replace both batteries with new ones. (Do not mix different types of batteries or new and old batteries.)
The remote controller is too far away from the CD receiver, or there’s an obstacle between them.
The CD receiver’s remote control sensor is being subjected to bright light (inverter-type fluorescent light or
sunlight).
The CD receiver is located behind the colored glass doors of a audio rack or cabinet.
Timers
Timer playback doesn’t work.
Make sure the clock has been set correctly (see pages 17, 42, and 43).
Timed operation will fail if the CD receiver is on at the specified On time, so make sure it’s set to Standby
(see page 46).
The timer may overlap with another timer. If you program several timers, make sure they don’t overlap.
If you press the [SLEEP] or [TIMER] button while a timed operation is in progress, the timer will be
cancelled.