Filter
Top Products
12
MOUNTING THE STEREO
Be sure you verify that the stereo is
connected properly (see “Testing the
Connections” on Page 11). Then fol-
low these steps to mount the stereo.
1. Make sure the ignition is turned
off, then disconnect the cable from
your vehicle’s negative (
–
) battery
terminal.
2. Disconnect the wire harness and
the antenna.
3. Press
RLS
on the right side of the
control panel to remove the con-
trol panel.
4. Remove the tape that holds the
sleeve in place and slide the
sleeve off of the stereo.
Note:
If you have a Cat. No. 12-
2154 stereo, you have already
removed the tape (while setting
2CH/4CH
). Continue with Step 5.
5. Turn the sleeve around so the flat
tabs on the front are facing you,
then insert it into the dash. Then
secure the sleeve to the dash by
bending out the tabs with a screw-
driver. Bend out all the side tabs.
6. If your vehicle has an existing
mounting hole behind the dash,
use pliers or a
5
/
16
-inch box-end
(new illus)
(illus)
(illus)
(illus)
12-2154.fm Page 12 Wednesday, July 14, 1999 3:34 PM