Filter
Top Products
29
3. If the fuse is blown, replace it. Use
only the supplied 1
1
/
4
-inch fuse or
a replacement fuse with the
proper rating (such as Cat. No.
270-1005). The fuse must be 1
amp.
4. Reassemble the fuse holder by
inserting the fuse into the longer
of the fuse holder’s ends, and
pushing together and twisting the
two parts until they latch together.
5. Reconnect the cable to the vehi-
cle battery’s negative (–) terminal.
Replacing the Blade-Type
Fuse
1. Disconnect the cable from your
vehicle’s negative (
–
) battery ter-
minal.
2. If the back of the stereo is not
accessible, remove the stereo
from the dash as described in
“Removing the Stereo From the
Dash” on Page 14.
3. Grasp the fuse’s plastic end and
pull it out.
4. If the fuse is blown, replace it. Use
only the supplied blade-type fuse
or a replacement fuse with the
proper rating (such as Cat. No.
270-1081). The fuse must be 10
amps.
5. Grasp the new fuse’s plastic end
and push it in.
6. If necessary, reinstall the stereo in
the dash.
7. Reconnect the cable to the vehi-
cle battery’s negative (–) terminal.
(illus - show blade-type fuse holder)
12-2154.fm Page 29 Wednesday, July 14, 1999 3:34 PM