Filter
Top Products
13
wrench to attach the short end of the supplied mounting bolt to the back of the
stereo.
7. Reconnect the wire harness and
the antenna.
8. Slide the stereo into the sleeve
until it locks into place.
9. If you are securing the stereo in
an existing mounting hole in the
dash, push the supplied rubber
mounting grommet onto the
mounting bolt.
Then push the mounting bolt (cov-
ered by the mounting grommet)
through that mounting hole and
make sure it is secure.
Otherwise, you can use one of the
supplied bolts (with attached
washer) to attach one end of the
supplied metal strap to the mount-
ing hole on the back of the stereo.
If necessary, bend the metal strap
to fit your vehicle’s mounting area.
Then use either the supplied
sheet metal screws or the other
bolt (with attached washer) to
attach the other end of the strap to
a solid metal part of the vehicle
under the dashboard. This strap
also helps ensure proper electrical
grounding of the stereo.
10. Reconnect the cable to the vehi-
cle battery’s negative (–) termi-
nal.
Then install the stereo’s
control panel (see “Installing the
Control Panel” on Page 15).
Note:
You might need to reset the
stereo’s clock after you reconnect
the cable to the vehicle battery.
(illus)
(illus - show
mounting grommet)
(illus - show bolt
washers))
(with attached
12-2154.fm Page 13 Wednesday, July 14, 1999 3:34 PM