Filter
Top Products
21
CQ-BT5107U
Alarm Setting
Alarm time setting
1
Hold down [ALM] (Alarm) for more than 2
seconds.
(Alarm time display)
“ALM ADJ” is displayed when the alarm time is
not adjusted.
2
Hold down [ALM] for more than 2 seconds
after the above display is shown.
Hour blinks
3
Adjust the hour.
[d]
: Sets ahead.
[s] : Sets back.
Hour entered
4
Push [ALM].
Minute blinks
5
Adjust the minute.
[d]
: Sets ahead.
[s] : Sets back.
Minute entered
6
Push [ALM] to complete.
Completed
The alarm is set to ON automatically after
complete alarm time setting.
Alarm indicator ( ) lights.
Notes:
¡When the clock (a page 9) is not set, perform
and complete the alarm time setting, the clock
time will set to “PM 1:00” automatically. Please
readjust the clock time depending on the actual
clock time.
¡Hold down [d] or [s] to change numbers
rapidly.
¡When you want to readjust the alarm time, repeat
steps
1 to 6.
Turning ON/OFF the alarm
1
Hold down [ALM] for more than 2 seconds.
(Alarm time display)
2
Push [ALM].
(Alarm ON/OFF setting)
3
Turn [ALM] clockwise or counterclockwise to
select alarm ON or OFF, then push [ALM]
again to confirm the setting.
(Select alarm ON, lights.)
Notes:
¡Before turn ON the alarm, make sure the alarm
time is set. Failure to heed this will cause invalid
selection of alarm ON.
¡Hold down [ALM] for more than 2 seconds
when the alarm is sounding also turns off the
alarm.
¡Access of alarm ON/OFF is available by push
[ALM] in the “Alarm time display”.
Activating snooze
Press any button on this unit when the alarm is
sounding.
The alarm will sound again in 9 minutes.
Note: If you do not turn the alarm off when the
alarm is sounding, the alarm sound will shut off
after an hour. (including the amount of time the
alarm was postponed (snooze))
[ALM]
[s]/[d]
CQ̲BT5107U 10/11/04 10:30 ページ 21