Filter
Top Products
22
CQ-BT5107U
Troubleshooting
If you suspect something wrong
Check and take steps as described below.
If the described suggestions do not solve the
problem, it is recommended to take the unit to your
nearest authorized Panasonic Servicenter. The
product should be serviced only by qualified
personnel. Please refer the checking and the repair
to professionals. Panasonic shall not be liable for
any accidents arising out of neglect of checking the
unit or your own repair after your checking.
Never take measures especially for those other
than indicated by
italic
letters in “Possible
Solution” described below because those are too
dangerous for users to handle themselves.
Warning
¡Do not use the unit in an irregular condition, for
example, without sound, or with smoke or a
foul smell, which can cause ignition or electric
shock. Immediately stop using the unit and
consult your nearest Servicenter.
¡Never try to repair the unit by yourself because
it is dangerous to do so.
Problem
Possible cause
a
Possible solution
No power to the unit
The power cord (battery, power and ground) is connected in the wrong
way.
a Check the wiring.
Sound is not generated.
The sound volume level is zero (MUTE).
a
Turn [VOLUME] clockwise to increase the sound volume.
The wiring of speaker lines are not correct, or a break or poor contact
arises.
aCheck the wiring in accordance with the wiring diagram.
Noise
There is an electromagnetic-wave generator such as a mobile phone near
the unit or its electrical lines.
a
Keep an electromagnetic-wave generator such as a mobile phone
away from the unit and the wiring of the unit. In case that noise
cannot be eliminated due to the wiring harness of the truck, consult
your nearest Servicenter.
The contact of the ground lead is poor.
aMake sure that the ground lead is connected to an unpainted part of
the chassis securely.
Noise is made in step with
engine revolutions.
Alternator noise comes from the truck.
aChange the wiring position of the ground lead.
aMount a noise filter on the power supply.
Common
Some operations are not
executable.
Some operations are not executable in particular modes such as menu
mode.
a
Read the operating instructions carefully and cancel the mode. If
the unit is still out of order, consult your nearest Servicenter.
No sound from speaker(s)
BALANCE/FADER setting is not appropriate.
a
Readjust BALANCE/FADER.
There is a break, a short circuit, poor contact or wrong wiring regarding
the speaker wiring.
aCheck the speaker wiring.
CQ̲BT5107U 10/11/04 10:30 ページ 22