Filter
Top Products
❏ To Remove the Display Unit
a) Push the right and left clamp plates outwards,
one at a time, and pull the display unit toward
yourself.
b) After removing the right and left clamp plates,
pull the unit with both hands till it comes off.
54
CQ-VA707N
E
N
G
L
I
S
H
51
Installation (Continued)
Push here to
remove the
clamp plates.
<Mounting the Control Unit>
Mounting Example
Stick Velcro tape o on the carpet and
mount the control unit on it.
Connect car radio antenna cord to the
control unit using radio antenna exten-
sion cord !9 between them.
Notes:
¡Never mount the control unit in any of the following locations to avoid damage due to overheating:
1. Near the heater port.
2. Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
¡Do not mount the control unit near the door, where it could be exposed to rain.
Control Unit
o Velcro Tape
Carpet
!9 Radio Antenna
Extension Cord
Car Radio
Antenna Cord
Rado Antenna Connector
Note: Some carpet materials may not
be suitable for this mounting method. In
this case, please contact your nearest
Panasonic Service center for service.