Filter
Top Products
C2988M-A (6/11) 19
ADVANCED SETTINGS
This menu is used to make advanced settings adjustments. To select the Advanced Settings menu options and ranges, press the right and left
arrows◀ or ▶on the remote control or the control panel, and then press ENTER.
The following table lists the advanced settings, menu options/ranges, and the default settings for video wall configuration.
VIDEO WALL
This submenu is used to make adjustments to the video wall display. To select the Video Wall submenu options and ranges, press the right and
left arrows W or X or the up and down arrows S or T on the remote control or control panel, and then press ENTER.
CONNECTION TYPES
Video walls can be configured in a 2 x 2 grid or a 3 x 3 grid, using the following three connection types.
Video (BNC type): Supports a maximum video wall grid of 2 x 2 monitors.
Figure 7. Video (BNC Type) Connection
Table H. Advanced Settings
Settings Menu Options/Ranges Default
Auto Adjustment No, Yes No
Image Position Up, Down, Left, and Right —
Phase 0 to 63 (only VGA mode) —
Clocks 0 to 100 (only VGA mode) —
VGA ADC Settings Default, User Default
Flesh Tone Off, Low, Medium, and High (only video mode) Off
IRFM On, Off Off
Baud Rate 115200, 38400, 19200, and 9600 115200
Video Wall (press X to display the Video Wall submenu) —
Factory Reset No, Yes No
VIDEO
IN
VIDEO
OUT
VIDEO
VIDEO
(1,1) (2,1)
(1,2) (2,2)
VIDEO
DVR
CAMERA
VIDEO