Filter
Top Products
En
56
11
Section
Audio Adjustments
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (LOW/MID/HIGH).
1 Press 5 or ∞ to select EQ MENU from the
AUDIO MENU, and press A.MENU.
EQ MENU is displayed.
BAND (band)
LEVEL (adjustment level)
FREQUENCY (frequency)
Q FACTOR (quality factor)
2 Press 5 or ∞ to select the item you want to
adjust.
3 Press 2 or 3 to adjust the item.
• +6 – –6 is displayed as the adjustment level is
increased or decreased.
Note
• If you make adjustments when a curve other
than CUSTOM2 is selected, CUSTOM1 curve
is updated.
Adjusting bass
You can adjust the cut-off frequency and the
bass level.
• In FRT1 mode, bass adjustment affects only
the rear output: front output cannot be
adjusted.
1 Press 5 or ∞ to select BASS from the
AUDIO MENU, and press A.MENU.
BASS adjustment indications are displayed.
2 Press 5 or ∞ to adjust the bass level.
Each press of 5 or ∞ increases or decreases
the bass level. +6 – –6 is displayed as the level is
increased or decreased.
3 Select the desired frequency with 2/3.
Press 2 or 3 until the desired frequency
appears in the display.
40—63—100—160 (Hz).
Adjusting treble
You can adjust the cut-off frequency and the
Treble level.
• In FRT1 and FRT2 modes, treble adjustment
affects only the front output: rear output cannot
be adjusted.
1 Press 5 or ∞ to select TREBLE from the
AUDIO MENU, and press A.MENU.
TREBLE adjustment indications are displayed.
2 Press 5 or ∞ to adjust the treble level.
Each press of 5 or ∞ increases or decreases
the treble level. +6 – –6 is displayed as the level
is increased or decreased.
3 Select the desired frequency with 2/3.
Press 2 or 3 until the desired frequency
appears in the display.
2.5k—4k—6.3k—10k (Hz)