Filter
Top Products
Additional Information
En
69
Using the Display Correctly
CAUTION
• If moisture or foreign matter should get
inside the product, turn OFF the power imme-
diately and consult your dealer or the nearest
authorized PIONEER Service Station. Using
the product in this condition may result in a
fire or electric shock, or other failure.
• If you notice smoke, a strange noise or
smell, or any other abnormal signs from the
display, turn OFF the power immediately and
consult your dealer or the nearest authorized
PIONEER Service Station. Using the product
in this condition may result in failure of the
system.
• Do not remove the rear cover of the display,
as there are high-voltage components inside
which may cause an electric shock. Be sure to
consult your dealer or the nearest authorized
PIONEER Service Station for internal inspec-
tion, adjustments or repairs.
Handling the Display
• When the display is subjected to direct sun-
light for a long period of time, it will become
very hot resulting in possible damage to the
LCD screen. When not using this product, close
the display and avoid exposing it to direct sun-
light as much as possible.
• The display should be used within the temper-
ature ranges shown below.
Operating temperature range: –10 to +50 °C
[+14 to 120 °F]
Storage temperature range: –20 to +80 °C
[–4 to +176 °F]
At temperatures higher or lower than the oper-
ating temperature range the display may not
operate normally.
• The LCD screen of this product is exposed in
order to increase its visibility within the vehicle.
Please do not press strongly on it as this may
damage it.
• Do not place anything on the display when it
is deployed. Also, do not attempt to carry out
angle adjustment, or opening/closing of the
display by hand. Applying strong force to the
display may damage it.
• Do not touch the LCD screen as this may
scratch it or dirty it.
• Be careful not to place anything between the
display and the main body when the
display is opening or closing. If an object gets
between the display and main body,
the display may stop working.
About the Liquid Crystal Display
(LCD) Screen
• If the display is near the vent of an air condi-
tioner when it is deployed, make sure that air
from the air conditioner is not blowing on it.
Heat from the heater may break the LCD screen,
and cool air from the cooler may cause mois-
ture to form inside the display resulting in possi-
ble damage. Also, if the display is cooled down
by the cooler, the screen may become dark, or
the life span of the small fluorescent tube used
inside the display may be shortened.
• Small black dots or white dots (bright dots)
may appear on the LCD screen. These are due to
the characteristics of the LCD screen and do
not indicate a problem with the display.
• At low temperatures, the LCD screen may be
dark for a while after the power is turned ON.
• The LCD screen will be difficult to see if it is
exposed to direct sunlight.
• When using a portable phone, keep the
antenna of the portable phone away from the
Display to prevent disruption of the video by the
appearance of spots, colored stripes, etc.
English
Español
Deutsch
Français
Italiano
Nederlands
14
Section