Filter
Top Products
1 Touch SETUP and VISUAL and then
touch PARENTAL.
2 Touch 0 to 9 to input the registered
code number.
3 Touch ENTER.
This enters the code number, and you can now
change the level.
# If you input an incorrect code number, the
icon is displayed. Touch C and input the cor-
rect code number.
# If you forget your code number, refer to If you
forget your code number on this page.
4 Touch any of 1 to 8 to select the desired
level.
The new parental lock level is set.
If you forget your code number
Refer to Changing the level on the previous
page, and touch C 10 times. The registered
code number is canceled, letting you register
a new one.
Setting remote control code type
When the remote control operation switch is
set to DVD, changing the remote control code
type enables you to operate the Pioneer DVD
player with the supplied remote control. There
are three remote codes, code type A, code
type B and code type AVH. When operating a
multi-DVD player (e.g. XDV-P650), select code
A. When operating this unit, select code AVH.
! With this unit, code B cannot be used.
1 Set the remote control selection switch
on the left side of the remote control to
the appropriate position with a pen tip or
other pointed instrument .
! If you select AVH mode, there is no need to
take the following procedure.
! If you select A/B mode, take the following
procedure and change the code type to the
appropriate type.
2 Press 7 and 0 on the remote control si-
multaneously to change the code type.
Initially, the code type is set to A. Each time
you press 7 and 0 simultaneously on the re-
mote control the code type switches between
A and B.
Operating this unit
En
41
Section
03
Operating this unit