Filter
Top Products
63
Appendix
Messages and how to react to them
The following messages may be displayed by your Navigation System.
❒ There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Message When What to do
You cannot use this function while
driving.
While trying to make a menu selec-
tion.
Pull over and come safely to a halt,
put the parking brake on, and then
try again.
This is not the appropriate disc.
Please insert the appropriate disc.
If you try to use a disc which is
incompatible with this system
(including the old version map disc).
Insert a suitable disc.
If you insert a disc upside down. Insert the disc with the label upward.
If the disc is dirty. Clean the disc.
If the disc is cracked or otherwise
damaged.
Insert a normal, round disc.
Irregular speed pulse signal is
detected. Please power off the sys-
tem and check the installation. After
you have checked, please re-boot the
system and press “OK”.
If the Navigation unit does not
receive the vehicle speed pulse.
Consult your Pioneer dealer.
Speed pulse wire is not connected.
System will start to learn without
speed pulse. Please keep in mind
that accuracy is not fully ensured
without speed pulse.
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly. Although it can be operated
with Simple hybrid mode without
connecting the speed signal input,
the precision of the positioning will
be less accurate.
Vibration is detected. Please power
off the system and check the installa-
tion. After you have checked, please
re-boot the system and press “OK”.
Sensor NG (Vibration)
While the vehicle is stationary, the
Navigation System is installed in a
place where the navigation unit may
be affected by a large vibration.
Re-install the navigation unit of the
Navigation System in a place where
the navigation unit will not be
affected by vibration.
Direction of G sensor is not correct.
Please power off the system and
check the installation. After you have
checked, please re-boot the system
and press “OK”.
Direction of G sensor is set incor-
rectly.
See the “Installation Manual” and set
the direction of G sensor correctly.
Sensor NG (BAD) angle The navigation unit is installed with
an extreme angle exceeding the limi-
tation of the installation angle.
Confirm the installation angle. (The
navigation system must be installed
within +30 degrees to –15 degrees of
the horizontal, or within five degrees
of your vehicle’s direction of travel.)
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service center.
Abnormal output of Gyrosensor is
detected.
Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
The route could not avoid the speci-
fied area.
If route setting cannot avoid speci-
fied Areas to Avoid.
Choose whether or not to try setting
a route through the area.
Your route could not be found. Route calculation has failed because
of malfunction of map data, software,
hardware, or disc.
•Change the destination.
•Clean the disc.
•Consult the Pioneer Local dealer if
this message persists.
Route calculation was not possible. Route calculation has failed because
of malfunction of map data, software,
hardware, or disc.
•Change the destination.
•Clean the disc.
•Consult the Pioneer Local dealer if
this message persists.