Filter
Top Products
64
Appendix
If a message about the PC card is dis-
played
• If there is no more space on the PC card or 300
items of data are already stored in one group,
either delete unnecessary data or create a new
group.
• If the data read from the PC card combined
with the data registered in the Address Book
exceeds 300 items, either delete unnecessary
data or reduce the amount of data read from
the PC card.
Route calculation was not possible
because the destination is too far.
The destination is too far. • Set a destination closer to the start-
ing point.
• Set one or more way points.
Route calculation was not possible
because the destination is too near.
The destination or way point(s) is too
close.
Set a destination [and way point(s)]
farther from the starting point.
Route calculation was not possible
due to traffic regulations.
•The destination or way point(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
•Your vehicle is currently in a Control
Traffic Zone (CTR) and the route cal-
culation is hampered.
•Set a destination and way point(s)
outside the CTR if you know where
the restricted area is.
•Try the destination or way point(s)
away from the currently set points to
some extent.
•Drive your vehicle to an unre-
stricted area and reset the destina-
tion and way point(s).
Route calculation was not possible
because no guidance can be pro-
vided around the destination or the
starting point.
The destination, way point(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible.
•Set a destination and way point(s)
on roads.
•Reset the destination after you drive
the vehicle to any road.
There is no route to the destination. The destination or way point(s) are in
an isolated island, etc. without a ferry
and the route calculation is impossi-
ble.
Change the destination.
The maximum number of registra-
tions has been completed. Please
clear existing registered items and
re-register current item.
If there are already 300 items when
you attempt to register an item in the
Address Book.
Delete some destinations as appro-
priate.
Memory is full. When the total 300 resistered points
are in the PC card and Address
Book, you attempt moving an item to
the Address Book from PC card.
Delete unnecessary data and try to
register again.
Irregular character strings. Please
input again.
A symbol that cannot be pronounced
was entered.
Enter a word that can be pro-
nounced.
An error has occurred. Please note
the following error code and switch
power off.
In the case of a system failure. Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
DVD Player is overheating. Discon-
tinue until temperature drops.
The built-in DVD drive has over-
heated.
Cut the power off, and wait for a
while before turning the power on
again.
DISC DATA READING With the map disc inside the Naviga-
tion unit, the NAVI source screen has
been displayed by pressing the
NAVI/AV button.
Select any other source besides
“NAVI SOURCE”, or press the NAVI/
AV button to switch to the Naviga-
tion map.
Message When What to do