Filter
Top Products
Black plate (38,1)
38 CRD3580-A/N
CUSTOM (graphic equalizer)50Hz (9-band
graphic equalizer)SFC (sound field control)
POSI (position selector)SUB.W (subwoofer)
80Hz (subwoofer setting)HPF (high pass filter)
Use the following instructions for more detail.
Note
If you do not operate the DSPfunction within
about 30 seconds, the display is automatically
returned to the source display.
Using the graphic equalizer
The graphic equalizer lets you adjust the
equalization to match car interior acoustic
characteristics as desired.
Recalling equalizer curves
There are six stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Button Display Equalizer curve
1 S-BASS Super bass
2PWFLPowerful
3 NTRL Natural
4 VOCAL Vocal
5 CUSTOM Custom
6 FLAT
Flat
! CUSTOM is an adjusted equalizer curve that
you create. Adjustments can be made with a
9-band graphic equalizer.
! When FLAT is selected no supplement or
correction is made to the sound. This is useful
to check the effect of the equalizercurves by
switching alternatively between FLATand a
set equalizer curve.
1 Press DSP to select the graphic
equalizer.
Press DSP until PWFL appears in the display.
#
If the graphic equalizer has been previously
set to an equalizer curve other than PWFL then
the title of that previously selected equalizer curve
will be displayed, such as S-BASS, NTRL, VOCAL,
CUSTOM,orFLAT.
2 Select an equalizer curve by
pressing 16.
Select the desired equalizer curve by pressing
one of the numbered buttons, from 16, which
correspond to the different equalizer curves as
listed above.
#
You can also sequentially select an equalizer
curve bypressing c or d.
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of FLAT, can be adjusted to a fine
degree (nuance control).
1 Recall an equalizer curve.
See Recalling equalizer curves on this page.
2 Press a or b to adjust the equalizer
curve.
Each press of a or b increases or decreases
the equalizer curve respectively.
+6 5 (or 6) is displayed as the equalizer
curve is increased or decreased.
#
The actual range of the adjustments are dif-
ferent depending on which equalizer curve is se-
lected.
Note
You can store the adjusted equalizer curve in
CUSTOM by pressing and holding button 5 until
MEMORYappears in thedisplay.
Digital Signal Processor
09
En
38
Section