Filter
Top Products
Black plate (48,1)
48 CRD3580-A/N
Understanding built-in CD
player error messages
When problems occur during CD play an error
message may appear on the display. If an error
message appears on the display refer to the ta-
ble below to see what the problem is and the
suggested method of correcting the problem.
If the error cannot be corrected, contact your
dealer or your nearest Pioneer Service Center.
Message Cause Action
CD ERR-
11, 12,17, 30
Dirty disc Clean disc.
CD ERR-
11, 12,17, 30
Scratched disc Replace disc.
CD ERR-14 Blank disc Check the disc.
CD ERR-
10, 11,12, 14,
17, 30,A0
Electrical or me-
chanical
Turn theignition ON
and OFF,or switch
to adifferent source,
then back tothe CD
player.
CD ERR-44 All tracksare skip
tracks
Replace disc.
HEAT CD player over-
heated
Turn offthe CD
player until theCD
player cools down.
Cassette tapes
! A loose, torn or warpedlabel on a cassette
tape can jam the cassette player. Do not use
cassette tapes with loose, torn or warpedla-
bels.
! Cassette tapes longer than C-90 (90-minute
tapes) can cause the tape to jam in the cas-
sette player. Do not usetapes longer than C-
90.
! Cassette tapes exposed to high temperatures
may warp and jam the cassette player. Keep
cassettes out of direct sunlight or places
where there are high temperatures.
! Store unused tapes in a tape case where
there is no danger of them becoming loose,
dirty or dusty.
Cleaning the playback head
If the head becomes dirty, the sound quality
will get bad and there will be sound dropouts
and other problems. If you have any of these
problems the head may need cleaning.
Music search and repeat
functions during tape
playback
Music search and repeat functions may not
work with these tapes:
! A tape with a gap of 4 seconds or less be-
tween songs
! A tape containing dialog or other non-musi-
cal content, with pauses lasting 4 seconds or
longer
! A tape with an extremely quiet passage in
the music lasting for 4 seconds or longer
Additional Information
En
48
Appendix