Rockford Fosgate RFX8210 Car Stereo System User Manual


 
– 19 –
– 18 –
S
OURCE
U
NIT
I
NSTALLATION
Source Unit Mounting Angle
Mount the Source Unit
as
close to horizontal
as possible
for optimum CD Player
performance
Mounting Angles
up to ±20˚
from
horizontal
can be
accommodated
Using the Installation Sleeve - Standard Mount
Mount the Installation Sleeve into a secure instrument panel
Bend Tabs on the installation sleeve which correspond to the
chart above
Bend Appropriate Tabs on all sides of the mounting sleeve
(Top, Bottom, Left & Right)
Installing the Source Unit – Standard Mount
CAUTION: Installation sleeve should be installed using the
appropriate tabs (refer to previous page)
Install Source Unit by sliding unit into installation sleeve until
it clicks into place
Mount Backstrap securely behind the instrument panel to
prevent source unit vibration
Backstrap Screw should be 6mm max (use supplied screw)
Connect Antenna to antenna jack on rear of source unit
Antenna Ground should read less than 0.05 between
antenna and chassis ground
Installing the Source Unit – ISO-DIN Mount
Remove Trim Piece and Installation Sleeve from source unit
Factory Bracket should align with two mounting holes on
each side of source unit
ISO Screws should be 6mm max (use supplied screws)
Connect Antenna to antenna jack on rear of source unit
Antenna Ground should read less than 0.05 between
antenna and chassis ground
Install Source Unit into instrument panel