Filter
Top Products
23
TROUBLESHOOTING
SYMPTOM DIAGNOSIS REMEDY
IR Remote
Error 7
(Focus Error)
The laser pick-up is defective
Repair the laser pick-up
Disc is warped, cracked, or
damaged
Put in a new disc
Error 9
(TOC Error)
Disc is warped, cracked, or
severely damaged.
Eject damaged disc from source unit and play
only non-damaged discs
The laser pick-up is defective
Have a service center repair the laser pick-up
NO CD
(No Disc Error)
Magazine is empty or not
installed in the unit
Check the magazine and insert discs
Error 5
(Elevator Error)
Magazine tray is jammed
Repair CD changer mechanism; then press
Reset
NO CONN
(Communication
Error)
8-pin DIN cable is
disconnected from the CDX
mechanism or source unit
Check the connection of 8-pin DIN cable
between the CDX and unit
CD Changer does
not operate
CDX cable is intermittent or
severely damaged
Check connections and repair or replace CDX
cable as necessary
CDX cable is disconnected from
the Source Unit or CD Changer
Check connections at the Source unit and CD
Changer and repair wiring as necessary
Communication issue
Press Reset on CD Changer
Disc is jammed in
the CD Changer
Disc load/unload problem Press Reset on CD Changer. If CD Changer still
does not operate, see your Local Authorized
Rockford Fosgate Dealer
IR Remote has
poor range
Batteries are weak
Check battery condition and replace as
necessary with (1) CR2025 (+3 volt) battery
Excessive dirt or dust on IR
Remote transmitter lens or unit
receiver lens
Clean transmitter and receiver lens (compact
disc logo) with Plexiglas solution and a
non-abrasive cloth as necessary
IR remote is outside of optimum
transmitting range
Operate IR remote within about 15 ft and ±45˚
from horizontal of the Source unit’s faceplate
High sunlight conditions Operate IR remote closer to Source Unit
IR Remote does
not work
(LED does not
illuminate)
Batteries are dead Check battery condition and replace as
necessary with (1) CR2025 (+3 volt) battery
Battery is installed incorrectly
Check battery installation and repair as
necessary (polarity is indicated on pc board)